Regular products will be inspected before they leave the factory. Only after they pass the inspection can they leave the factory and the unqualified products be rebuilt. The same is true for aluminum shredders, so how does it perform joint inspection?
1. Each aluminum shredder shall pass the inspection by the manufacturing and inspection department and be issued with the product certificate before it can appear.
2. Tools should be tested in air running step by step, and the test should be carried out at rated speed. Operating time is not less than half an hour.
3. The type inspection of aluminum shredder, the formulated type identification of new or old products produced in the factory shall be carried out in the factory for no less than 8 hours.
4. After the formal production, if the structure, process and material have great changes, the outside structure of the whole machine should be observed to see whether the seam is right or not when the performance of the product may be affected.
5. When the aluminum shredder is tested normally, attention should be paid to whether there will be abnormal noise and the blades are intertwined.
6. Check whether the size of the finished material is suitable for the user's needs after testing.
7. The results of factory inspection shall conform to the satisfaction of users with the equipment.
8. Each production equipment is equipped with a special label.
Factory Address: Longjiang West Road, Shangjie District, Zhengzhou City
Contact number: +86-371-67666660 676667
Mobile phone: 0086 13523465141
After-sales Service Department: 0371-67666667
Related Products
Email
Telephone
Leave Message
