Aluminum shredder reducer installation three steps
Before the first step of installation, confirm whether the motor and reducer are intact, and strictly check whether the dimensions of the parts connected to the reducer are matched. Here are the dimensions of the positioning boss of the motor, the input shaft and the groove of the reducer, and the tolerances.
In the second step, screw down the screw on the outer side of the flange of the reducer flange, adjust the clamping ring of the PCS system so that the side holes are aligned with the dust holes, and insert the hexagon socket into the hexagon. After that, remove the motor shaft key.
The third step is to naturally connect the motor to the reducer. When connecting, it must be ensured that the output shaft of the reducer is concentric with the input shaft of the motor, and the outer flanges of the two are parallel. As the heart is inconsistent, it will cause the motor shaft to break or the reducer gear to wear.
E-mail : shuguangzhongji@163.com
Cel : 0086-13523465141