Safetyregulationsformetalshredders!

1. The Metal Shredder's console should enable the operator to see the working conditions of each department, the instrument indication signal is accurate and reliable, the electric mixer's console should be padded with rubber board or dry wood board.

 

2. Metal Shredder inspects transmission mechanism, working device, brake, etc., should be tightened and reliable to ensure normal operation. Large gear ring, pulley and other parts should be fitted with protective cover.

 

3, Metal Shredder aggregate specification should be consistent with the performance of the mixer, not allowed to exceed the permitted scope.

 

4. Metal Shredder adds grease (grease) to the big gear ring, runway and other parts of wear and rotation.

 

5. Metal Shredder empty car running, check the rotating direction of mixing drum or mixing blade, the operation of each working device, brake, confirm normal, can work.

 

6. When Metal Shredder feeds, it is forbidden to put head or hand into hopper and rack to inspect or probe the feeding situation. No hand or tool can be used in running to pull material out of mixing drum.

 

7. When the Metal Shredder hopper is lifted, it is strictly prohibited to work under it or pass through it. The pillow pad of the hopper should be arranged at the bottom of the hopper, and the hopper must be fastened with chain when clearing the hopper.

 

8. Metal Shredder feeding into the mixing drum should be carried out in operation; adding new materials must be unloaded from the original concrete in the mixer before proceeding. No mixer can be stopped or stopped during full load.

 

9. In case of accidents or failures during the operation of Metal Shredder, the power supply should be cut off immediately, the concrete in the cylinder should be removed and repaired.