Howtosolvetheblockagefaultwhenusingpapershredder?

The recycling of waste cartons has great economic and social benefits, and for waste carton recycling enterprises, in the process of recycling cartons, waste carton pulping is a key step, paper shredder is a necessary normal production equipment for waste carton recycling plant. Paper shredder is easy to plug when working, and seriously affects normal production. So how to solve the problem of blockage caused by paper shredder?

 

Paper shredder blockage is one of the common faults in the use of the shredder. It may be a design problem, but it is mostly caused by improper operation.

 

(1) the feeding speed is too fast and the load increases, resulting in blockage. In the process of feeding, pay attention to the problem of large deflection angle of the ammeter pointer at any time. If it exceeds the rated current, it will show that the motor overloading and long time overload will burn out the motor. In this case, the feed door should be immediately reduced or closed, and the feeding way can also be changed, and the feed quantity can be controlled by increasing the feeder. There are two kinds of feeder, manual and automatic, and users should choose suitable feeder according to the actual situation. Due to the high speed and heavy load of the shredder, the load fluctuation is strong. Therefore, the current of the shredder is generally controlled at about 85% of the rated current.

 

(2) the discharge pipe is not smooth or clogged and the feed is too fast, which will cause the tuyere of the tearing machine to be blocked; the mismatch with the conveying equipment will cause the wind to be weakened or the wind is blocked. After the fault is detected, the conveying equipment should be cleared and changed, and the feed quantity should be adjusted to make the equipment run normally.