Howtodealwiththeblockageofindustrialshredder?

 

Industrial shredder or regular equipment in the present life, from the point of quantity we produce waste every day, for many years in the future still need to use, with shredded industry vendors would upgrade of industrial shredding machine products, it will be more and more important, until can not be replaced, so industrial shredding machine after long time work, appear jams phenomenon? Let jap teach you the environment.

After customers buy industrial shredding machine, in practical production, probably because of feeding too fast too fast, cause industrial shredding machine production was blocked, so industrial shredding machine plugging of the problems, how to solve?

Industrial shredding machine in the process of using, if long time doesn't clean easily appear jams phenomenon, at first you will not find, but eventually it will be late, it is easy to cause the failure, affect production efficiency oh, on this aspect in the following we are going to do a detailed explanation.

Operator, we must be on a regular basis to do a good job of screening equipment, pay attention to the maintenance of at ordinary times, the emergence of failure, or less, the industrial except the shredding machine quality closes nevertheless, of course, it is important to note that maintenance don't be too, such as lubricants add too much at once, cleaning too hard-working, but is harm for their use.

Industrial shredding machine equipment failure requires you to pay attention to in time, if it is found that industrial shredding machine production, and the same raw material, check the damper is in place and pipes with and without air leakage, etc., industrial shredding machine jams are common faults, the likelihood has four kinds:

1. may be the design problem of the body;

2.the raw material is put in too fast;

3. it is the pipe of the discharge is not smooth;

4. possible raw material moisture content is too high, it is important to pay special attention to the bearing at work, its temperature is too high, or has the problem such as noise, are generally lubricating oil or the matching of the bearing cover and shaft tight, just can have this kind of situation