Wheel sand washing machine

Product introduction

Sand washing machine, also called stone washing machine, is mainly used to remove impurities (such as dust) from sand products. In most cases, water is used for washing, so it is called sand washing machine.The sand washing machine developed by Red Star Machinery is a sand washing equipment developed by using advanced technology and combining with the actual situation of the sand and gravel industry.It has the characteristics of cleaning height, reasonable structure and large output. During the sand washing process, there is less sand loss, especially the transmission part is isolated from water and sand, so its failure rate is much lower than the current commonly used sand washing machine.

Working principle

When working, the power device drives the impeller to slowly rotate after deceleration by the V-belt, reducer, and gear. The sand and gravel enter the washing tank from the feeding trough, roll under the impeller, and grind each other to remove impurities covering the surface of the gravel. At the same time, it destroys the water vapor layer covering the sand to facilitate dehydration;At the same time, add water to form a strong water flow, timely take away impurities and foreign objects with small specific gravity, and discharge them from the overflow washing tank. Finally, the sand is introduced into the discharge tank from the rotating impeller, and the sand cleaning process is completed.

Advantages

1. Simple structure and stable operation

The structure is simple, the processing capacity is large, the power consumption is small, and the cleaning degree is high. The novel sealing structure, fully enclosed oil bath transmission device, and adjustable overflow weir plate ensure the durability of this series of products, with good cleaning and dehydration effects, and the fine-grained products are kept intact.

2. Clean sand, high output, less sand loss

There is very little loss of fine sand and stone powder, high efficiency of selection and washing, which can fully meet the requirements of high-grade materials.

3. Few wearing parts, long service life and easy maintenance

Except for the screen, there are almost no wearing parts. In rare cases, maintenance is required. The service life is relatively long. At the same time, the bearing is separated from water and materials in the design.It is easy to maintain and avoid damage to the machine due to premature contamination and rust.

Technical data