Whatistheworkflowofjawcrusher

The jaw crusher can crush the raw materials of different sizes into small pieces with uniform particles. The jaw crusher can be matched with the ore dressing equipment, sand and gravel equipment, or can be used alone. The jaw crusher can also produce roadbed stone, railway track slag and construction sandstone aggregate. The smashing machine is pided into a coarse crusher jaw crusher and a fine crusher jaw crusher, also known as the PE series jaw crusher and the PEX series jaw crusher. The following describes the workflow of the jaw crusher.
 
When the jaw crusher is working, the motor drives the eccentric shaft to rotate through the pulley, so that the moving jaw is periodically close to and away from the fixed jaw, so that the material has multiple crushing, smashing, rolling, etc., so that the material becomes larger and smaller, and gradually falls. Until it is discharged from the discharge opening. The jaw crusher (smashing) is mainly composed of the main parts such as the body, the eccentric shaft, the connecting rod, the raft and the adjusting mechanism. The power is transmitted to the connecting rod through the V-belt, and the movable raft is driven to break the material. The discharge granularity is adjusted by a hand wheel, a cross bar or the like.
 
The jaw crusher is a crushing machine that uses two jaws to squeeze and bend materials, and to crush coarse or medium crushed materials. The crushing mechanism is composed of a fixed jaw and a movable jaw. When the two jaws are close to each other, the material is broken, and when the two jaws are separated, the block smaller than the discharge opening is discharged from the bottom. Its crushing action is intermittent.
 
This crusher is widely used in industrial sectors such as mineral processing, building materials, silicates and ceramics due to its simple structure, reliable operation and ability to break hard materials.

Tel : 0086-371-67666667

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141