ShredderfactorytaughtyouhowtoinstallPlasticshredder!

After we buy Plastic shredder, shredding machine installation work must be well done, believe that everyone is no stranger to the daily work of shredding machine, Plastic shredder is a type of shredding machine, is now used more extensive range of shredding machine Plastic shredder is different from the single axis, it tore up ability stronger, tear is more efficient, was welcomed by the market. When we use the shredder for production, we need to install the shredder. The installation process is the foundation of production for the shredder, so we must take it seriously.

The installation work of Plastic shredder should pay attention to three convenient impacts.

1. The circuit problem before installation is Plastic shredder. The circuit problem is the most basic and important problem. We need to choose the right wire to run the wire to make sure the two-axis shredder works properly. It should be noted that we need to install a switch control knife outside the switch of the shredder, which can cut off the circuit in case of any problem.

2. The installation of Plastic shredder shall be fixed to ensure that there is no loosening. This phenomenon will be ignored by many people, because feelings will not have any impact, it is not a big deal, but the opposite is true. Big problems are caused by small problems. If biaxial shredding machine fixed no fixed well, so long time production is easily torn variant is not strong, in the long run it will cause vibration and eventually lead to the noise of the shredding machine is more and more big, and easy to cause the damage of the shredding machine, so we need to fixed biaxial shredding machine to ensure normal production work for a long time.

3.Plastic shredder will be tested by air machine after the installation is completed. Open the two-axis shredder for idling.