With the application of the Metal Shredder because of the wide application of Metal Shredder in all industries, we have a lot of touch on Metal Shredder, and how much knowledge about the performance and application of Metal Shredder. However, there is no further understanding of how to operate and use Metal Shredder correctly and to use some of the common sense in the application. Today, we have come to Henan Bob company to share some common sense about Metal Shredder in the operation of the machine.
Grasp and understand the correct start-up process of the shredder and related matters, can be very good to ensure the smooth operation of equipment production. For Metal Shredder's correct boot operation and matters, Xiaobian summed up the following six points for us.
Tearing machine
1, open the motor to make the motor unloaded, to investigate the conditions of each part of the rip machine, and check the operation of each part after the operation is normal.
2. Investigate whether there is magnetic and conflict. If necessary, the operation should be aborted immediately to see the cause of the failure.
3. The sieve must be sturdy, sealed, and can not be leaked.
4. If abnormal noise, blockage of discharging materials, overheating of bearings or motors are found during operation, feeding should be stopped, parking inspection should be made, and troubleshooting should be done.
5, after the operation is finished, empty operation for 2-3 minutes, and the material in the machine can be completely eliminated before stopping the mill and fan.
6, the operation is strict to ensure production. It is forbidden to advance the rotational speed of the shredder at will; the opening pin on the pin shaft is often checked and replaced immediately if excessive wear or tear occurs.
Related Products
Email
Telephone
Leave Message
