ThereasonforWoodShreddertostopturning

The sudden stop of the rip equipment is not common, but the sudden stop of the machine is also a lot of trouble, especially if the technical manual is not skilled in the operation of the equipment, it is easy to make a mistake in this emergency and cause the loss to the factory. So, what should be done once the equipment is suddenly shut down?

 

The sudden shutdown of the shredding equipment is mainly caused by the following aspects: 1. suddenly power failure, 2. click damage, 3. equipment dies.

 

No matter what circumstances cause the equipment to stop, we should first close the equipment one by one according to the order of operation. Then arrange the technical personnel to carry out the troubleshooting and repair, if it is found that the outage caused by the power failure, the residual material in the rip equipment should be cleaned up, and then the power can be opened in accordance with the operation order. If the power motor is out of order, the motor should be carefully inspected and replaced at the time of burnout, so as to avoid affecting the production. The case of machine card death is not much, the main cause may be that the size of the feed is too large or the feed speed is too fast, so it is necessary to stop the equipment urgently to prevent the equipment from being too long and cause the equipment to be damaged.

 

After understanding the relevant knowledge, the user can handle some emergency situations with the operator, and we will also update some of the knowledge about the operation of the rip device at any time, so that the user can have a more thorough understanding of the equipment.