MetalShredderbearingheatingiscausedbythefollowingproblems

During the work of Metal Shredder, the bearing will generate heating phenomenon, which will directly affect the normal operation and production power of the equipment. Kowloon mechanical prompts broad users, Metal Shredder equipment operation process, bearing heating and bearing position noise, to handle in time, which causes the formation of bearing fever phenomenon? The Kowloon machine gives you a brief introduction.

 

Metal Shredder

 

One, oil pipe oil leakage, the lack of oil supply pressure;

 

Two. The oil pipe is blocked and the grease activity is not smooth.

 

Three. The lubricating oil is too dirty and mixed with sundries.

 

Four. The space between the axle bush and the shaft is too small.

 

Five, the selection of lubricating oil is not suitable, the granularity is too large or too small.

 

Six, before winter starts, there is no oil heater, and the oil is too sticky.

 

Seven, in summer, the lubricating oil from the oil pump did not go through the oil cooler or the oil cooler, such as pipe blockage, poor water flow and water cut.

 

Eight, bearing cycle cooling water device defects, such as clogging;

 

Nine, the discharge port is too small (the thrust plate is too long) to cause the eccentric shaft to bear too much force.

 

Ten, the transmission belt is too tight, the bearing force is too large.